colorFabb catalogue

Available colors

BLACK

DARK GRAY

CLEAR

Specification

colorFabb nGen_FLEX ± 0.1 mm 1.13 g•cm-3 130C

Material: Diameter Tolerance: Density: Temperature resistance:

Tips & Tricks

240-260C 30 - 60 mm/s 80C + BuildTak / LokBuild / coroPad

Adviced 3d printing temperature: Adviced 3d print speed: Advised Heated bed:

Build platform nGen_FLEX gives best results on a buildTak, coroPad or LokBuild covered buildplate, heated at around 80C. Make sure the distance between nozzle and buildplate is not too close, the first layer should not be squeezed too much to make removal of parts easier. After printing, cooling down to room temperature and reheating to 85C can make part removal easier. Cooling It’s always best to print with the least amount of cooling to get the best possible layer-to-layer adhesion. For better performance on complex overhanging surfaces or small areas, cooling is needed. In case of nGen_FLEX we recommend starting with 50% cooling.

35